Hello CP/M and Z80 Friends,

I put this final release on my web site www.yaze-ag.de.

I update the whole dokumentation, also yaze(1) the man page.

Windows binaries for X86_64bit and X86_32bit have I produced.

The emulator runs on all Rasperry Pi and other ARM-deveices
(32Bit and 64Bit).

The new features are:

1. You can define a clock rate in the monitor of YAZE-AG, so the
emulator runs then at this frequency. E.g. place "clock 4000" for the
frequecy 4000 kHz (4.0 MHz). You can define any Clrockrate e.g.
3957 for 3957 kHz (3.957 MHz).

2. A "window size handler" determines the coordinates (lines, columns)
of the used terminal emulator (xterm, gnome-term,
mintty(Cygwin/Windows, ...) and set the lines and columns veriables
in the system control block (SCB) of CP/M 3.1. The patched Wordstar
4.00 (see A:) and the CP/M 3.1 system commands/utilities uses this
two variables over the standardized BDOS3-interface (call to 0005H)
to setup the screen.

When you unpack the tar file you find the whole dokumentation in the
"doc_html" directory in html. Click on "index.html" so that your web
browser starts with this file. There is also Install-2.51.0.html.

Best regards
Andreas Gerlich
--
University of Ulm, Germany
Dipl.-Ing. (FH) Andreas Gerlich
Open Source Projekt: Yet Another Z80 Emulator by AG (YAZE-AG)
www.yaze-ag.de